Device error messages

Card read error or chip reader not working on a card terminal

What to do when a card terminal shows a card read or chip error: reinsert, check the card, try tap, test another card to tell a bad card from a bad reader.

Applies to
All payment terminals
Last reviewed
Oct 27, 2026 by Abdul Rashid

Ask Allstar AI about this guide

Check first

  • Does the error happen with one card or with every card?
  • Was the card inserted chip first, chip facing up, and left in until the terminal said to remove it?
  • Does the same card work by tap?

A card read or chip error means the terminal could not talk to the chip. Most of the time the card was inserted the wrong way, pulled out too early, or the card's chip is damaged. Testing a second card tells you whether the card or the terminal's reader is at fault.

Before you start

  • Have a second chip card from a different bank ready for a test.
  • Chip cards go in chip end first with the chip facing up (Ingenico) and stay in until the terminal says to remove them.

Steps

  1. Remove the card and insert it again: chip end first, chip facing up, pushed fully in. Leave it in until the terminal says to remove it. Expected: the chip is read. Ingenico and Verifone both list a wrongly inserted or early-removed card as the first thing to check.
  2. Look at the card's chip. If it is cracked, scratched or heavily soiled, the card is the likely problem. Expected: you know whether to suspect the card.
  3. If the card and terminal support contactless, cancel and run the sale again with a tap. Expected: the sale completes by tap.
  4. Insert a different chip card, from a different bank if possible. Expected: if it reads, the first card is faulty. If it also fails, the terminal's chip reader is the likely problem. Verifone's troubleshooting uses this same test.
  5. If only the customer's card fails, ask for another payment method. Swipe it only if the terminal itself prompts for a swipe after the chip failure. Expected: the sale is completed without forcing a swipe. Visa says a chip card swiped by choice can leave the merchant liable for fraud.
  6. If every chip card fails, stop using the chip reader. Do not push anything into the slot or try to clean the reader contacts. Contact Allstar support. Expected: the terminal is checked or replaced without further damage.

If that did not work

If every card fails on one terminal, the chip reader needs attention. Contact Allstar support with the model, serial number, payment application, processor and the exact message on screen. If a tamper or security message appears, stop, do not reboot repeatedly, and contact support.

Sources

Stop and contact support if

  • Every chip card fails on the terminal: contact Allstar support.
  • Any tamper or security message on screen: stop, do not reboot repeatedly, contact support.
  • Something is stuck in the card slot: do not try to dig it out. Contact Allstar support.

Contact Allstar support (support@allstarterminals.com, 888-403-7066, Monday to Friday 9 AM to 5 PM Central) with the model, serial number, payment application, processor and the exact message on screen.

Contact support about this

Notes

  • The exact error text differs by payment application (for example 'Card read error', 'Chip error' or a prompt to insert again). No single manufacturer string is used here.
  • Checking the chip for damage is general guidance; the cited manuals say to test with several cards and to check the magnetic stripe for damage, but do not describe cleaning a card.
  • Ingenico says not to clean electrical connections. No cited source gives a procedure for cleaning a chip reader slot, so none is given.

Sources

Was this guide helpful?

More device error messages guides